Modster COMPASS Betriebsanleitung Seite 21

Betriebsanleitung
Cut a length of Dyneema cord at around
100mm, connect eyelet of main sail and
main boom bearing.
Unleash the Dyneema cord taped on
top of jib sail, tie it to a clevis through a
bowsie.
Cut a length of Dyneema cord at about
100mm, connect eyelet on jib sail and SR4
on jib boom.
www.modster.at
Cut a length of Dyneema cord at about
150mm, connect eyelet of main sail and
main boom silicone ring.
Unleash the Dyneema cord taped on
bottom of jib sail, tie it to the eyelet on jib
boom.
Cut a length of Dyneema cord at about
100mm, connect eyelet of jib sail and
clevis through a bowsie.
MODSTER COMPASS
Cut a length of Dyneema cord at about
1600mm, tie both ends with a clevis, then
hook one side on eyelet of hull, the
other on backstay crane hole. Connect a
bowsie on cord closer to hull side.
Cut a length of Dyneema cord at about
60mm, connect eyelet on jib sail and
eyelet on jib boom as shown in picture.
Cut a length of Dyneema cord at about
700mm, tie one end on the clevis as
shown in picture.
21