Binding The Transmitter And Receiver; Radio Controller - Modster COMPASS Betriebsanleitung

Betriebsanleitung

6. Binding the transmitter and receiver

Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single specific
transmitter. When a receiver is bound to a transmitter, the receiver will only respond to that specific transmitter.
The yacht normally comes with bound Transmitter and Receiver.
If you need to rebind for any reason, please follow these steps:
1. With the transmitter switched ON
2. Power on the receiver, then press the binding button several times within 5 seconds.
3. After the receiver LED stop flashing, it means the binding is done.
4. Now you are ready to run.

Radio Controller

The yacht comes with a 2.4G 4-channels radio system. For sailing you will only need 2 channels.
Learn all instructions as below:
1. Sail stick controls maximum expand angle of main sail and jib sail. When you move sail stick in upper position, both sails will be
allowed with larger expand angles when wind comes. Both sails can expand to left or right depends on wind direction.
2. Rudder stick controls rudder to left or right direction.
3. Sail trim / rudder trim allows to adjust neutral position of sail / rudder if needed to center.
4. Reverse function switchers allow to reserve specific stick. Because sailing yacht only needs 2
POWER LED
Sail stick
Sail trim
No function
Power Switch
www.modster.at
Sail stick reverse
MODSTER COMPASS
Rudder stick reverse
Dual Rate Switcher
Rudder stick
No function
Rudder trim
No function
25