Modster COMPASS Betriebsanleitung Seite 19

Betriebsanleitung
5. Installation and rigging guide
Setup the display base as shown in picture.
Insert the tubes into the sockets, no gluing is
required.
Setup the keel, water-proof rubber piece into hull by
HM5*50mm screw, using a H4.0 mm allen key.
Install the cord holder to hull deck with two PWA 2*10*8mm
screws.
www.modster.at
Fix the keel, water-proof rubber piece and ballast with a
HM5*25mm screw, using a H4.0mm allen key.
Insert the rudder from hull bottom to deck through the rudder
arm, connected with a clip, make sure rudder is able to rotate
freely. Then insert push rod through the knob on rudder arm,
keep rudder in center position and tighten the knob with a
H2.0mm allen key.
Insert long mast through main boom, till in the hull. Ensure the
mast screw in the main boom slot.
MODSTER COMPASS
19