Modster COMPASS Betriebsanleitung Seite 23

Betriebsanleitung
MODSTER COMPASS
Move Silicone Rings("SR" for short) to appropriate position as shown in picture. If further rigging needed, adjust refering to below instruc-
tion:
(1) Move SR4 to adjust jib sail until it is appropriately tight, but leaving little bending room so that it can sail. Normally if in strong wind
environment it needs more bending room, in gentle wind environment it needs less bending room.
(2) Move SR5 to adjust the expand angle when you power on and move sail stick. Make sure jib sail is able to travel larger angle than main
sail(normarlly jib sail travels about 90° - 100°, main sail travels about 80° - 90°). If it is too tight(smaller angle), move SR5 to SR4 direction to
increase the angle. If it is too loose(larger angle), move SR5 to SR6 direction to decrease the angle.
Notice: If need to adjust main sail expand angle, move SR3 to SR2 direction to increase angle, or move SR3 to mast direction to decrease
angle. But normally position of SR3 is preset and no need to adjust.
(3) Move SR6 to adjust the Dyneema cord tied in step 24 if it is too tight(move to SR6 direction) or if too loose(move to SR4 direction), to
keep the jib boom with 30mm - 35mm expand distance to mast when sail stick at lowest position.
(4) Move SR7 to adjust distance between jib boom and mast if too close(move to SR6 direction) or if too far away(Move to counterweight
direction) to keep about 5mm - 8mm between jib boom and mast.
(5) Rotate counterweight on front of jib boom by clockwise direction to adjust its position, ensuring jib boom swing CG is located on SR7.
(6) Connect three luff rings with main sail and long mast.
www.modster.at 23