General Setup (Applies For All Parameters) - Mettler Toledo M800 Schnellstartanleitung

6

General Setup (applies for all parameters)

(PATH: H \ CONFIG \ Guided Setup)
h
h
14
Select the desired Channel for the guided setup and in the same line the parameter.
If Auto is selected, M800 transmitter automatically recognizes the type of sensor.
The channel can also be fixed to a certain measurement parameter, depending on
the type of trans mitter.
Press the corresponding button to measurement M1 to configure the measurement.
NOTE: For M800 2-channel or 4-channel versions only: If the guided setup for a flow
sensor has been selected, the calibration factor of the sensor from the sensor
label or certificate can be entered. Press therefore the "CAL FACTOR" button.
For sensor types "High" and "Low" slope and offset can be entered. In case
of sensor "Type 2" the slope followed by a table of "K" and "F" values can be
entered.
Assign the corresponding output signal Aout'X' to the measurement through press-
ing "YES".
Enter the Min Value, that corresponds with start point of the analog output range.
Enter the Max Value, that corresponds with end point of the analog output signal.
Additional settings can be done by navigating to the next page of the menu.
Assing the corresponding Set Point'X' to the measurement through pressing "YES".
Select the Type for the setpoint.
The type of the setpoint can be "High", "Low", "Between", "Outside" or "Off". An
"Outside" setpoint will cause an alarm condition whenever the measurement goes
above its high limit or below its low limit. A "Between" setpoint will cause an alarm
condition to occur whenever the measurement is between its high and low limits.
NOTE:
If the type of set point is not "Off" additional settings can be done.
See the following description.