Fitting/Changing The Saw Blade; Operation; Switching On And Off; Sawing Methods - Parkside PAAS 12 A2 Originalbetriebsanleitung

Fitting/changing the saw blade

Wear protective gloves when fitting/changing a
saw blade .
♦ Turn the quick-release chuck
go in the direction of the arrow and hold it in
this position.
♦ Push the required saw blade
release chuck as far as the stop.
CAUTION!
► The teeth of the saw blade
downwards!
♦ Let go of the quick-release chuck
return to its initial position.
The saw blade is now locked.

Operation

Switching on and off
Switching on
♦ Press the safety lock-out
♦ Press the ON/OFF switch
Switching off
♦ Release the ON/OFF switch
PAAS 12 A2
as far as it will
into the quick-
must point
; it must
.
.
.

Sawing methods

A) Working without the grip bracket
(see fig. D)
■ For branches of a larger diameter or wood,
plastic or building material, work without the
grip bracket . The workpiece must be right
up against the base plate. Use a rocking cutting
motion for round workpieces.
A1) Sawing flush
■ Flexible saw blades allow you to saw off pro-
truding workpieces such as pipes located close
to the wall, provided the saw blade is long
enough.
1. Place the saw blade
2. Bend it by applying lateral pressure to the recip-
rocating saw so that the base plate
into contact with the wall.
3. Switch the appliance on as described and saw
off the workpiece by applying constant pressure.
A2) Plunge cutting (see fig. E)
CAUTION! RISK OF KICKBACK!
► Plunge cuts may only be made in soft
materials (wood or similar).
1. Place the reciprocating saw with the lower edge
of the base plate
the appliance on.
2. Tilt the reciprocating saw forwards and plunge
the saw blade into the workpiece.
3. Position the reciprocating saw vertically and
continue sawing along the cutting line.
B) Working with the grip bracket (see fig. F)
♦ Push down lightly and move the saw
downwards.
directly against the wall.
comes
on the workpiece. Switch
GB │ IE │
9 ■