Sensor Installation; General Information - Siemens Sitrans F Serie Schnellstartanleitung

Transducer Identification
The transducer part number located on the front face provides a detailed identification. For
example, the
①
②
Note
Check to make sure that the transducers are a matched set with the same serial numbers
and marked with an "A" and "B" (e.g., 19256A and 19256B).
Note
Transducer Model names for Version 3 op systems are as follows: 1011H Hi Precision, 1011
Universal and 991 Universal
3.3

Sensor Installation

3.3.1

General information

Reflect and Direct Mounting Modes
Reflect and Direct mounting modes are supported for clamp-on transducers. The flowmeter
recommends a mounting mode after analyzing your pipe and liquid data entries.
Note
For Direct Mount refer to the flowmeter manual.
Mounting Supplies
The following items will be needed to mount the transducers:
● Flat blade screwdriver
● Mounting Frames or Mounting tracks
FUE1010 IP40 (NEMA 1) Energy Portable
Compact Operating Instructions, 5/2009, A5E02384186-03
Part Number: 1011PPS-D1 means:
Model
Size
Commissioning
3.3 Sensor Installation
23