PIEPS DSP Pro Bedienungsanleitung Seite 20

AddITIO n AL Fun CTI O n S FO R PIEP S dSP PRO
5. InCLInOMETER
The PIEPS DSP PRO has an integrated three dimensional inclinometer.
You can quickly check the angle of a slope:
1) Put your ski pole in slope line at that point
of the slope you want to measure.
2) Hold the SCAN button for 3 seconds while in SEND-mode.
3) Put your PIEPS DSP PRO next to the ski pole and the
angle of the slope is indicated. The display switches back
into SEND-mode automatically after 20 seconds.
Important! During the measurement the PIEPS DSP PRO is transmitting.
In case of an emergency the beacon can be lost. PIEPS recommends to make
measurements in avalanche dangerous areas only in combination with the PIEPS
BACKUP!
S OF TWARE u P dATE
Every PIEPS DSP PRO/DSP SPORT can be tested and updated with the latest
PIEPS firmware. With your safety in mind our R&D team is constantly working
on improving the firmware to reflect and incorporate all our experiences in the
field. Every new firmware is developed to be compatible with any PIEPS DSP
PRO/DSP SPORT. You can have your PIEPS DSP PRO/DSP SPORT checked
and its firmware updated at every PIEPS Service Center and PIEPS distributor.
How can you display your firmware?
When you are switching the beacon on the latest firmware
is indicated on the display.
Further information about the PIEPS firmware
can be found on www.pieps.com
38 | 06/15
BATTE RIE S
The battery compartment is located on the backside of the housing. The safety screw connection
can be easily opened and closed using a coin. Only use battery type alkaline LR03/AAA and
always replace all 3 batteries with new ones of the same type. Never use rechargeable batteries
and always change all batteries at the same time!
The battery indication is based on measuring the actual battery voltage. Due to the temperature
influence the actual battery voltage may vary. A change from cold (outdoor) to warm (mountain
hut) the battery capacity typically recovers.
PIEPS dSP PRO
3/3 filled 400–250 h SEND
2/3 filled 250–120 h SEND
1/3 filled 120–20 h SEND
empty 20 h SEND (+10°C) + 1 h SEARCH (-10°C)
empty, flashing last reserve, transceiver can be switched off at anytime
IMPORTAnT!
During a longer time of no use (e.g. summer) the batteries have to be removed from
the PIEPS DSP PRO/DSP SPORT. Damages because of leaked batteries are not included in the warranty.
electromagnetic Compatibility (eMC) and PiePs auto-antenna-switch:
All beacons are very sensitive against electrical and magnetic interferences. Due to this, it's
a recommendation from all manufacturers that minimum distances should be maintained
between avalanche beacons and electronic, magnetic or metallic influences (like radios,
mobile phones, MP3-players, bunch of keys)!
pIEpS recommends: Minimum distance in SEND-mode: 20 cm | SEARCH-mode: 50 cm
Your pIEpS DSp pro/DSp SporT has an auto-antenna-Switch included:
If there is an external influence the strongest antenna will begin transmitting.
Further information can be found in the chapter "Intelligent Transmitter".
PIEPS dSP SPORT
200–120 h SEND
120–60 h SEND
60–20 h SEND
06/15 | 39