PIEPS DSP Pro Bedienungsanleitung Seite 13

QuICKSTART In 3 STEP S
Your pIEpS DSp pro/DSp SporT
is ready to use directly out of the box!
Step 1:
Putting on the carrying
harness, place the shoulder
strap loop over head and
shoulder. Lead the body strap
around your back, fix the quick
fastener and adjust to the
Carrying recommendation:
proper length.
carrying the PIEPS DSP PRO/DSP SPORT using the
supplied carrying harness. The neoprene-material
Step 2:
is water repellent, for the functional control take a
Switch on the PIEPS DSP PRO/
look on the transmit light, the "Quick-Pull-System"
DSP SPORT (SEND) and wait
enables you to access the PIEPS DSP PRO/DSP
for the results of the self-check.
SPORT very quickly in case of emergency. Insert the
beacon with the display towards the body for best
Step 3:
protection (see picture).
Put the PIEPS DSP PRO/DSP
SPORT back into the carrying
system and enjoy your tour.
„Quick-Pull-System"
WARnInG!
The volume level of an avalanche There is also the option to carry the PIEPS DSP PRO/
transceiver can be up to 100 dB DSP SPORT with the supplied hand loop in a securely
closeable trouser pocket without a protective case.
(decibels), and may cause damages
to your hearing! Make sure that The hand loop can be fixed around your wrist during
there is always a minimum distance the search to rule out losing the PIEPS DSP PRO/DSP
of 50 cm between the avalanche SPORT.
transceiver and your ears!
24 | 06/15
PIEPS recommends
SWIT CHInG On | SEL F-CHE CK
Press the button „Lock" and push the main switch up to the position „SEARCH". Release the
button „Lock" and push down the main switch till latching noticeable in the position „SEND".
The PIEPS DSP PRO/DSP SPORT is now in SEND-mode.
During power-on, the PIEPS DSP PRO/DSP SPORT will carry out an extensive self-check. All
relevant hardware-components are tested and the latest firmware is displayed. During the
self-check, a minimum distance of 5 meters should be maintained to other beacons, and any
electronic or magnetic interference.
If the self-check is successful, "OK" is indicated on the display. In the event of a device warning,
an alert signal sounds and the display indicates "E" in combination with a warning-code
(overview table in chapter warning-codes). If the warnings are still shown in an interference-
free area the PIEPS DSP PRO/DSP SPORT is not fully functional. Bring your PIEPS DSP PRO/DSP
SPORT to a PIEPS authorized service center.
Display Display Display
Firmware-Version Self-check OK Self-check error
BE ACOn-CHE CK | GROuP- CHECK
Despite the extensive self-check, PIEPS recommends that all users perform a beacon check
before each tour! Your PIEPS DSP PRO/DSP SPORT is equipped with a group-check-function. A
check is simple and efficient, it tests to be sure your partners avalanche transceiver is sending a
signal and whether the frequency is in compliance with standards.
06/15 | 25