Analog Output; Editing The Tag Number - JUMO dTRANS T04 Betriebsanleitung

3.5.3 Analog output

The Edit  Analog output function can be used to configure the
type of analog output (changeover between current and voltage
output) and the response to probe break.

3.5.4 Editing the TAG number

Using Edit  TAG number (14 characters max.) you can save an
identifier (measurement point designation) to the transmitter.
By means of the menu function Data transfer  Data transfer to
device or the
transferred to the transmitter, together with the input parameters. If
you want to enter the TAG number only (all other settings are
retained), then use the Online editing function.
h Position the mouse pointer in the working area, above the "TAG
number" display, and press the right mouse button.
h Start the Edit TAG number online function by clicking on it with
the left mouse button.
The setup program reads the current number out of the connected
transmitter and sends the new number back to the transmitter after
the entry (conclude the entry with the Transfer) button.
3 PC setup program
icon in the toolbar, the TAG number setting is
23