Flotec Autojet 1000 Bedienungs- Und Wartungsanleitung Seite 10

GB
A cut-off valve (7) should also be installed downstream from the check valve, to facilitate servicing operations. Piping
should be fitted so that vibrations, when existing, tension and weight do not affect the pump. Piping should be routed
along the shortest and straighter track, avoiding an excessive number of bends. Verify that the motor is properly ventilated.
For permanent installations, it is advisable to fix the electropump to the supporting base, connect the system with a
section of non flexible pipe and insert a layer of rubber (or another anti-vibration material) between the supporting base
and the pump, in order to reduce vibrations.
ATTENTION!!!
Connection, suction and delivery pipes should be connected with the utmost care. Make sure that all connections
fixed by means of screws are sealed. Avoid applying excessive stress to tighten the screws of connections or of
other components. Use a Teflon tape to completely seal all joints.
These pumps are suitable to be used close to garden ponds or similar locations. In these places, the installation of a
device with differential current not exceeding 30 mA is mandatory. For the continued use in these same locations, the
equipment must be attached to a steady support to prevent drops.
Ch. 4 Electrical connections
WARNING
DANGER
Electric shock
risk
DANGER
Electric shock
risk
Overload protection
FLOTEC AUTOJET series pumps have a built-in thermal protection switch. The pump stops if an overload condition
occurs. The motor restarts automatically after it has cooled down (see point 3 of the Troubleshooting section for
information on causes and corrective actions).
Electrical extension cables must have a minimum section of H07 RN-F. The plug and connections should be protected
by water splashes.
The device has a power cable.
Contact a specialised electrician.
Ch. 5 Starting the unit (see Fig. 1)
WARNING
WARNING
WARNING
Instructions for a safe pump start
Avoid exposing the pump to humidity. Protect the pump from rain, making sure that there are no leaking fittings over the
pump. Avoid using the pump in wet or damp environments.
8
Verify that the voltage and frequency of the electropump shown on the nameplate
correspond to those available on the mains.
The installer must make sure that the electric system is grounded
in accordance with the law in force.
Make sure that the electric system has a high-sensitivity circuit
breaker
Use the electropump for the applications listed on the nameplate.
Do not operate the pump dry, since lack of water could cause it to
overheat. In this case, the water inside the system gets very hot, so
there is a risk of scalding. Take off the plug and let the system cool
down.
Do not run the electropump with a completely closed delivery.
Ä
=30 mA (DIN VDE 0100T739)
3
GB