thermo spectronic Helios Gamma Benutzerhandbuch Seite 7

6. Local Control display shows this sequence if OK
appear sequentially as each test is completed.
-
SPECTROPHOTOMETER INITIALISING
0.000 A
546.0 nm
MENU
Connecting up a Printer to a Standalone system
SETUP
PAGE
8. To set up the Printer in the software:
POWER UP THE SYSTEM AND ALLOW TO INITIALISE
- From the HOME page, press MENU
- from the MENU page, press SETUP
- select PRINTER using the cursor keys,
- press ENTER. The PRINTERS page is displayed with the default
printer selected.
- press ENTER again to display the Printer Menu and using the cursor
keys, select the required printer.
- press ENTER.
THIS COMPLETES THE INSTALLATION OF A STANDALONE
2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
INSTALLATION
√ INITIALISE OPTICS
√ TEST W LAMP
√ INITIALISE MONOCHROMATOR
√ TEST OPTICS
√ OPTIMISE MONOCHROMATOR
√ SET DEFAULTS
PLEASE WAIT
PRINT MODE nm
λ
* PRINTERS *
PRINTER TYPE : INTERNAL
PRINTER
EPSON 9 PIN
INTERNAL
SYSTEM
English
THIS COMPLETES
THE INSTALLATION
OF A STANDALONE
SYSTEM - IF YOU
WISH TO INSTALL
A PRINTER GO TO
POINT 7.
7. ENSURE THAT THE
SPECTROPHOTOMETER
IS TURNED OFF -
Now, connect the printer
to the Parallel port on the
spectrophotometer using
the cable supplied.
GD Issue 1 (08/2000)