Internal Printer; Internal Printer Operation - thermo spectronic Helios Gamma Benutzerhandbuch

INTERNAL PRINTER

The Internal Printer is a factory-fitted thermal-head printer. It is supplied with
a roll of 11.2cm wide single-ply thermal paper. Paper rolls may be ordered
separately under the following part number: 4401 161 00391
For long-term storage, it is recommended that the paper is kept away from light
and at room temperature.
A red warning stripe is printed on the paper within 1 metre of the end of the
roll. It is recommended that the roll is replaced as soon as the warning stripe is
visible to avoid possible paper jams.
The printer is fitted with a Line Feed Button. Press this once to switch the
printer off-line and feed the paper though the printer. Press the button a
second time to put the printer back on-line. Do not press the Line Feed Button
during printing as this will cause a internal error condition which can only be
rectified by restarting the instrument.
To replace the paper roll:
Cut the paper at the end of the new roll in a "V" to make a point at the end of
the paper.
Carefully feed the printer paper ( from the bottom of the roll, i.e. shiny side
down ) into the back of the printer using the Line Feed Button.
Keep the Line Feed Button depressed until the paper emerges "squarely"
through the top slot of the printer housing.
50
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
INTERNAL PRINTER
English GD Issue 1 (08/2000)