Lamps - thermo spectronic Helios Gamma Benutzerhandbuch

LAMPS Page - Gamma
The lamp functions are available directly from the LAMPS key on the SETUP and
MENU pages.
This page shows the status of the Tungsten Halogen and Deuterium lamps
whether ON, OFF or FAILED, and their appropriate energy levels. It also allows
the lamp hours to be reset and the Deuterium lamp to be switched on or off.
The HOURS parameter states the number of hours that the lamp has been in
use.
The Tungsten Halogen lamp should be replaced after 2000 hours. The Deuterium
lamp should be replaced after 1000 hours.
Whenever a lamp is changed then the hours parameter should be reset to zero.

* LAMPS *

TUNGSTEN : ON
HOURS : 987
ENERGY : 99%
D2 : STRIKING
HOURS : 234
ENERGY : 96%
40
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SETUP
RESET W HRS - Resets hours and measures energy at the
appropriate wavelength. ALLOW THE LAMP AT LEAST 10 MINUTES
TO WARM UP BEFORE RESETTING ITS HOURS.
RESET D2 HRS - Resets hours and measures energy at the
appropriate wavelength. ALLOW THE LAMP AT LEAST 10 MINUTES
TO WARM UP BEFORE RESETTING ITS HOURS.
W ENERGY - ALLOW THE LAMP AT LEAST 10 MINUTES TO
WARM UP BEFORE MEASURING ITS ENERGY. CLEAR BOTH
SAMPLE AND REFERENCE BEAMS BEFORE MEASURING LAMP
ENERGIES.
D2 ENERGY - ALLOW THE LAMP AT LEAST 10 MINUTES TO
WARM UP BEFORE MEASURING ITS ENERGY. CLEAR BOTH
SAMPLE AND REFERENCE BEAMS BEFORE MEASURING LAMP
ENERGIES.
SWITCH D2 -Turns the Deuterium lamp ON or OFF depending on its
current status.
English GD Issue 1a (12/2000)