Status Leds; Software - ACD GRUPPE M260SE Set Kurzübersicht

15.2.3 Status LEDs

The status LEDs belonging to the DS260 docking station for the mobile terminal and the spare battery are
described below.
Fig. 12: DS260NP status LEDs
Mobile terminal:
The power LED is green:
The charge LED is red:
The charge LED is green:
The charge LED is not lit:
Connect-LED:
The temperature range for charging the M260SE battery is 0 °C to 40 °C. There is a temperature sensor
integrated in the DS260. Charging is stopped, when trying to charging out of this temperature range. The
charge LED is blinking red.
A completely discharged battery with 3,400 mAh capacity is charged to 50 % after about 1.5 hours and
charged to 95 % after about 3 hours. After about 4.5 hours, the battery is fully charged.
Spare battery:
Spare battery charge LED is red:
Spare battery charge LED is green:
Spare battery charge LED is not lit:

15.3 Software

The mobile terminal software is described in various documents such as "Administration Manual" or
"Programming Manual". These documents are available via the following Internet addresses in the customer
portal: https://www.acd-gruppe.de/downloads/
Please contact our support hotline if you require further support
///ACD Elektronik GmbH
Engelberg 2
88480 Achstetten
Tel.: +49 7392 708-488
E-mail: support.technik@acd-elektronik.de
Web: www.acd-gruppe.de
The support hotline is available from 08:00 to 17:00 on Mondays to Thursdays and from 08:00 to 15:00 on
Fridays.
M260SE_Set_Kurzübersicht_Brief Overview_V1.22_de_en.DOC
The docking station is supplied with current via the power supply unit.
The mobile terminal is charging.
The mobile terminal is fully charged.
No mobile terminal is inserted in the docking station.
No function with DS260 Standard
The spare battery is charging.
The spare battery is fully charged.
No spare battery is inserted in the docking station.
28 / 35