Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
10
INTRODUCTION
400 Power Pulse is an inverter power source that can
carry out the following welding modes:
•
M
MA
•
C
ELLULOSE
•
A
A
RC
IR
•
C
T
ONTINUOUS
The generator has:
A front control panel.
A rear panel fitted with a military connector for remote
control, a switch, a power supply cable, a connector for
cooling unit power supply, a plug for gas pre-heating unit;
in the lower side there is a plug for the bundle of cables
to be connected to the remote control device and a
socket to be connected to the positive cable.
On the front: a positive (+) welding socket and a negative
(-) welding socket.
THE MACHINE CAN ALSO BE CONNECTED TO
ENGINE-DRIVEN GENERATORS AS LONG AS THEY
HAVE A STABILIZED VOLTAGE.
11
INSTALLATION
The generator in question must be supplied with a rated
voltage of 3x400V~±15%/50-60Hz.
Connect the generator to the mains supply and position
the switch I1 to the "I" position, and the welding machine
will set itself into the last welding process used.
Using the front panel, choose the new welding process.
12
REAR PANEL
• C1: Supply cable 5x6mm² with a length of 2m.
• I1: Supply switch. It is the switch to turn on the
machine. It has two positions, "I" and "O". When the
machine is connected to the mains with I1 in the "I"
position and in the MMA mode there is power between
the negative and positive clamps.
• J1:
6-pole
military
CONTROL. A manual remote control can be connected
to the power source via the military connector found on
the panel which allows setting the current value that is
necessary for welding from a position far from the site in
which the welding machine is positioned.
• F1: Fuse. The protection fuse of the auxiliary
transformer providing the supply to the tow-wire motor
has a value of 1A DELAYED.
E
n
E
n
W
IG
ELDING
connector
for
REMOTE
g
l
i
s
h
g
l
i
s
h
4
0
0
P
o
w
e
r
P
4
0
0
P
o
w
e
r
P
• Z1: Connector to power the cooling unit. If it is not
connected, continue to keep it closed with the cover
because there is an alternating 380V voltage!
• J3: Pre-heating unit power supply socket. It is a
SHUCO 230Vac socket that can deliver a maximum
power of 130W. It is protected internally by a self-
restoring fuse.
13
REAR OUTLETS
• P3: Socket for connecting the power cable between
the power source and the remote control device.
• J4: Connector of the bundle of cables for connecting
the power source to the remote control device.
14
FRONT OUTLETS
• P1: NEGATIVE (-) welding socket.
• P2: POSITIVE (+) welding socket.
6
6
u
l
s
e
u
l
s
e
Werbung
Inhaltsverzeichnis
