Inhaltsverzeichnis; General Power Tool Safety Warnings - Lincoln 1800 Gebrauchsanweisungen

Models 1800, 1842, 1842E, 1844, 1844E
PowerLuber Grease Gun
Table of Contents
General Power Tool Safety Warnings.......2
!"#$%&$' !()#*+,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,-
Service..........................................4
!"#$%&$(*%./0,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,1
Tool Use and Care...................................4
General Description.................................5
Inspection...........................................6
Operation.........................................6­7
Charger Operation...................................8
Safety Instruction for Charger
and Batteries.....................................10
23"4.5#5' 6 %#7' ( /5' 8 (9*0' : %0*,,,,,,,,,,,,,,;;<;-
Troubleshooting...........................14
French Version.....................................15
German V ersion.....................................28
Spanish V ersion.....................................41
GENERAL POWER TOOL SAFETY
WARNINGS
Read all safety warnings and
instructions. Failure to follow the warnings
and instructions may result in electric shock,
!"#$%&'()"$*#"+),*$+&-,"./
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains­operated (corded) power tool or
battery­operated (cordless) power tool.
1) Work area safety
a) Keep work area clean and well lit.
Cluttered or dark areas invite acci­
dents.
b) Do not operate power tools in ex­
plosive atmospheres, such as in the
!"#$#%&#'()'*+,,+-.#'./01/2$3'4+$#$'
or dust. Power tools create sparks which
may ignite the dust or fumes.
c) Keep children and bystanders away
while operating a power tool. Distrac­
tions can cause you to lose control.
2) Electrical safety
a) Power tool plugs must match the
outlet. Never modify the plug in any
way. Do not use any adapter plugs with
earthed (grounded) power tools. Un­
=.5%&#5'"4>?0'(/5'=(*$@%/?'.>*4#*0'7%44'
reduce risk of electric shock.
Page Number ­ 2
b) A void body contact with earthed or
grounded surfaces such as pipes,
Page
radiators, ranges and refrigerators.
There is an increased risk of elec­
tric shock if your body is earthed or
grounded.
c) Do not expose power tools to rain
or wet conditions. Water entering a
power tool will increase the risk of electric
shock.
d) D o not abuse the cord. Never use the
cord for carrying, pulling or unplugging
the power tool. Keep cord away from
heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase
the risk of electric shock.
e) When operating a power tool out­
doors, use an extension cord suitable
for outdoor use. Use of a cord suitable
for outdoor use reduces the risk of elec­
tric shock.
f) If operating a power tool in a damp
location is unavoidable, use a residual
current device (RCD) protected supply.
Use of an RCD reduces the risk of
electric shock.
NOTE: The term "residual current device
(RCD)" may be replaced by the term
"ground fault circuit interrupter (GFCI)" or
"earth leakage circuit breaker (ELCB)".
3) Personal safety
a) Stay alert, watch what you are do­
ing and use common sense when
operating a power tool. Do not use
a power tool while you are tired or
1%2#"'56#'/%*1#%&#'()'2"14$3'+.&(6(.'
or medication. A moment of inattention
while operating power tools may result in
serious personal injury.
-7'8$#'!#"$(%+.'!"(5#&5/9#'#01/!,#%5:'
Always wear eye protection. Protective
equipment such as dust mask, non­skid
safety shoes, hard hat, or hearing protec­
tion used for appropriate conditions will
reduce personal injuries.
c) Prevent unintentional starting. Ensure
the switch is in the off­position before
connecting to power source and/or
battery pack, picking up or carrying
the tool. Carrying power tools with your
&/?#9'./'*@#'07%*$@'.9'#/#9?%A%/?'".7#9'
tools that have the switch on invites
accidents.
d) Remove any adjusting key or wrench
before turning the power tool on.
A wrench or a key left attached to a
rotating part of the power tool may result
in personal injury.
Form 403865