Operating Elements And Connections; Safety Notes - Monacor SECURITY TVCCD-800ECOL Bedienungsanleitung

1

Operating Elements and Connections

GB
(figs. 1 and 2)
1 Lens cover
2 C-mount adapter for screwing on a lens with C-mount
thread
3 Threaded ring for screwing on a lens with CS-mount thread
4 Setscrew to correct the mechanical focus setting for the
lens
5 Jack for connection of a lens with iris remote control for
automatic iris control by the camera, see fig. 3 and chap. 4
6 Selector switch "LENS" to adjust the camera to the AI lens
type used [AI = "Auto Iris" (automatically controlled iris)]
"VIDEO": for a video signal controlled lens
"DC": for a DC voltage controlled lens (DC lens)
7 Power indication
8 – 12 Keys to make the camera settings via the on-screen menu
13 Adapter base with threaded jack (6.3 mm/
the camera mounting; it can be screwed to the upper or
lower side of the camera
14 Ground screw connection "F.G"; the camera can be ground-
ed via this connection
15 Spring-loaded terminals for connecting the voltage supply
(12 V or 24 V~/50 Hz)
16 Jack "REMOTE" to make the menu settings via an RS-232
connection, e. g. with a computer
17 BNC jack for the video output
18 Spring-loaded terminals with the connections:
"D/N IN":
for switching between day operation (D = DAY) and night
18
operation (N = NIGHT) by means of an external switch
against ground
contact open = day = colour operation
contact closed = night = B/W operation
"G":
common GROUND connection for "D/N IN" and "M/D
OUT"
"M/D OUT":
pulse output for the evaluation of the motion detection;
signal type can be selected: 5 V signal or open collector
(max. 16 V/100 mA)
2

Safety Notes

The camera corresponds to the directive 89/336/EEC for electro-
magnetic compatibility.
The camera is suitable for indoor use only. For outside mounting
it must be placed into a weatherproof protection housing.
1
/
" thread) for
4
Protect the camera against dust, humidity, and heat (admissible
ambient temperature range 0 – 40 °C).
Protect the CCD image sensor against dust and impurities and
never touch it with your fingers.
If no lens has been screwed on, always place the lens cover (1)
on the lens holder of the camera to protect the CCD image sen-
sor.
When adjusting the camera, take care that the sunlight does not
directly hit the lenses of the lens assembly. Otherwise the CCD
image sensor chip may be damaged.
For cleaning only use a dry, soft cloth, by no means chemicals
or water.