Applications; Lens - Monacor SECURITY TVCCD-800ECOL Bedienungsanleitung

No guarantee claims for the camera and no liability for any
resulting personal damage or material damage will be accepted
if the camera is used for other purposes than originally intended,
if it is not correctly connected, operated, or not repaired in an
expert way.
If the camera is to be put out of operation definitively, take it to
a local recycling plant for disposal which is not harmful to the
environment.
3

Applications

The high-resolution camera TVCCD-800ECOL is designed for use
in video surveillance systems. It features a very high sensitivity
and a high dynamic range and has the following characteristics:
– switching between day operation and night operation (colour
and B/W) manually, via control input, or automatically; thus, an
optimum colour reproduction during the day and a clear recog-
nizability during the night are ensured.
– motion detection for an adjustable picture range with variable
control output for external alarm evaluation
– adjustable backlight compensation
– white balance to be selected between manual, semi-automatic,
and permanent control
– selectable automatic gain control (AGC)
– electronic shutter
– suitable both for video signal controlled or DC voltage controlled
AI lenses and for lenses with manual iris adjustment
– picture can be synchronized to mains frequency
– convenient setting of the camera via an on-screen menu
– all settings of the on-screen menu can also be remote-con-
trolled via RS-232C
– insertion of a title of up to 15 characters at any desired picture
position
4

Lens

Both a lens with an iris to be remote-controlled (AI lens) and a lens
with manual iris adjustment can be used.
Do not use lenses of a weight exceeding 450 g as they may
cause balance problems.
1) Remove the lens cover (1).
2) When using a C-mount lens, screw it on the C-mount adapter
ring (2). When using a CS-mount lens, remove the adapter ring
(2) and screw the lens directly on the threaded ring (3).
3) When using an AI lens (video signal controlled or DC voltage
controlled), connect it via the automatic iris jack (5) to the cam-
era. For this purpose the supplied plug can be used. For the
contact configuration of the jack see fig. 3. Set the switch
"LENS" (6) to the type used ("DC" or "VIDEO").
Switch "LENS" in position
Pin
"DC"
1 damp -
2 damp +
3 drive +
4 drive -
When using a lens with video signal controlled iris, adjust its
ALC mode to average value detection ("A" or "Av" = average).
If the peak value detection ("P" or "Pk" = peak) has been se-
lected, a flickering may occur when controlling the iris.
Switch "LENS" in position
"VIDEO"
power supply +12 V
not connected
output video signal
ground
GB
19