Safety Instructions; Switching Off - Truma Ultraheat S 3004 Gebrauchsanweisung

Safety instructions

Repairs may only be carried out by an expert.
The heater casing becomes hot by design during
operation. Due diligence towards third parties
(particularly small children) lies with the user.
The warm air outlet of the heater must not be blocked
under any circumstances. Therefore, no textiles or similar
are to be hung in front of or over the heater for drying. Incor-
rect use can damage your heater caused by overheating. Do
not bring any combustible objects in the vicinity of the heater!
It is in the interest of your safety to comply with this request.
During the initial operation of a brand new appliance (or after
it has not been used for some time), small quantities of fumes
and a slight odour may briefly occur. It is a good idea to allow
the device to run at maximum output during this time, and
ensure that the area is well ventilated.
Guarantee claims, warranty claims and acceptance of liability
will be ruled out in the event of the following:
– Modifications to the device (including accessories)
– Failure to use original Truma parts as replacement parts and
accessories
– Failure to follow the installation and operating instructions
This may also invalidate the device operating permit, which in
many countries also denotes cancellation of the vehicle oper-
ating permit.
Attention: In spite of careful manufacturing, the heater
may have sharp edges, therefore always wear protec-
tive gloves during maintenance and cleaning work.
6
Operating instructions
Always observe the operating instructions prior to start-
ing! The vehicle owner is responsible for correct operation of
the appliance.
Control panel with room thermostat
c
230 V ~
a = Rotary switch "Off"
b = Rotary switch "On"
Operating level 500 – 1000 – 2000 W
c = Control knob for room temperature
(illuminated by green "operation" LED)
Start-up
Before switching on, be sure to check that the campsite
power supply fusing corresponds to the set operating
levels (b) (see "Technical data").
Important: The cable drum must be fully unwound in order
to prevent the power cable of the recreational vehicle from
overheating.
To switch on, move rotary switch to desired operating level (b).
The green LED for operation is lit and simultaneously indi-
cates the selected room temperature setting.
Set the desired room temperature at the control knob (c).
The thermostat setting on the control panel (1 – 9) must be
determined individually depending on the heating requirement
and the type of vehicle.

Switching off

Switch the heater off using the rotary switch (a).
Disposal
The device must be disposed of in accordance with the ad-
ministrative regulations of the respective country in which it is
used. National regulations and laws (in Germany, for example,
the End-of-life Vehicle Regulation) must be observed.
Ultraheat
b
2000
a
b
500
b
1000