LD Systems LD WS10002X Bedienungsanleitung Seite 15

Aim the transmitter directly at the receiver ("line-of-sight" contact between the devices). Do not position the
receiver near metal objects/surfaces or digital devices (CD players, computers, etc.).
Position the receiver so that it is not directly in front of a wall and is at least 1 m above the floor. Cell phones, bi-
directional radio devices, etc. can interfere with the radio link between transmitter and receiver and should not be
operated in the vicinity of the transmitter.
PROBLEM
No sound or volume too low
Distortion or unwanted noise
Increasing distortion
Substantial difference in levels in comparison with wired operation with
the same source or when other guitars or microphones are used
TIPS FOR IMPROVING PERFORMANCE:
DISPLAY
Transmitter: on/off indicator
is off
"Power" indicator is off
Receiver: RF indicator is on
Receiver: RF indicator is off.
Transmitter: indicator is on
Transmitter: battery status
indicator is on
Receiver: RF indicator is on
Transmitter: battery status
indicator is on
SOLUTION
Make certain that the unit is con-
nected correctly.
Make certain that the AC adapter is
plugged into the device correctly and
the other end is plugged in correctly
on the back.
Increase the volume. Increase the
gain setting on the transmitter.
Check the power connections of the
receiver and the connected amplifier
and/or mixer.
Do not position the receiver near
metal objects. Check whether the
transmission path between trans-
mitter and receiver is unobstructed
("line-of-sight" contact).
Position the transmitter closer to
the receiver. Make certain that the
transmitter and the receiver are
using the same frequency
Replace the batteries
Remove possible sources of
interference (CD players, computers,
digital effects units, in-ear monitor-
ing systems, etc.)
Replace the batteries
Adjust the gain setting on the
transmitter and the volume on the
receiver accordingly.
15