Menu Level 4: Default Setting - Waeco CoolAir CA-800-Mercedes-2 Einbauanleitung

CA-800-Install.book Seite 33 Mittwoch, 20. Februar 2008 12:28 12
CoolAir
➤ Use the buttons + or - (see fig. 7 on page 5, Pos. 6 and 7) to select the
➤ Press the operating mode button (see fig. 7 on page 5, Pos. 4) to
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 3 and can use the + and - buttons to switch

6.3.5 Menu level 4: Default setting

You can return the parameters you set in configuration mode on menu le-
vels 1 to 3 to the default settings:
➤ Start configuration mode (see chapter "Start and end configuration
✓ The first digit of the display (see fig. 7 on page 5, Pos. 5) shows the
➤ Press the + button (see fig. 7 on page 5, 6) three times to switch to
✓ The digital display shows
➤ Press the operating mode button (see fig. 7 on page 5, Pos. 4) to re-
✓ The digits in the display
➤ Press the + button.
✓ The digital display shows
➤ Press the operating mode button (see fig. 7 on page 5, Pos. 4) to
✓ The parameters set in configuration mode are returned to the default
✓ You are now in menu level 4 and can use the + and - buttons to switch
operating mode with which the system starts.
ID number
0
1
2
3
confirm your entry.
between menu levels.
mode" on page 30).
menu level and the second and third show the parameter which can
be set.
menu level 4.
turn the system to its default settings.
confirm your entry.
setting.
between menu levels.
Operating mode
Automatic mode
Operating mode 1
Operating mode 2
Operating mode 3
--
.
--
flash.
00
.
Installation
33