Resetting The Default Settings - G&D FIBREVision-MC4-ARU Installation Und Betrieb

Resetting the default settings

This function resets the default settings of the FIBREVision system. By performing
this function, the default settings of the FIBREVision system mentioned on page 15
are reactivated.
How to reset the default settings:
1. Press Hotkey+Backspace
mode. If the hotkey delay is active, press the key combination for seven
seconds.
2. Press the setup key listed below to reset the default settings:
 resets the default settings
D
1. Use the terminal emulator to establish the connection to the FIBREVision
system.
2. Use the arrow
3. Press the Enter
4. Press the Enter
process by pressing
(default:
keys to select the row
key to reset the default settings.
key to respond to the prompt for confirmation, or cancel the
Q .
Ctrl+Backspace ) to activate the setup
Set System Defaults .
G&D FIBREVision · 37
Configuration