Troubleshootin - Klarstein Parforce Duo Handbuch

EN

TROUBLESHOOTIN

Problems
Gas leaking from
cracked/cut/
burned hose
Gas leaking from
LP tank
Gas leaking from
LP tank valve
Gas leaking between
LP tank and regula-
tor connection
Fire coming through
control panel
Grease fire or continu-
ous excessive flames
above cooking surface
Burner will not light
using ignites.
24
Possible cause
Damaged hose
Mechanical failure due to
resting or mishandling.
Failure or tank valve from mis-
handling or mechanical failure
Improper installation, connection
not tight, failure of rubber seal
Fire in burner tube section of
burner due to partial blockage
Too much grease build-
up in burner area
Gas issues
1.Trying to light wrong burner
2. Burner not engaged
with control valve
3. Obstruction in burner
4.No gas flow
5.Vapor lock at cou-
pling nut to LP tank
6. Coupling nut ad LP tank
valve not fully connected.
Prevention/ Solution
Turn off gas at LP tank, if hoes is cut or cracked,
replace hose.See LP tank lead test and con-
nection regulator to the LP tank
Turn off LP tank valve
Turn off LP tank valve. Return LP tank to gas supplier
Turn off LP tank valve, remove regulator from cylinder
and visually inspect rubber seal for damage, see LP
tank test and connection regulator to the LP tank
Turn off control knobs and LP tank valve. Af-
ter fire is out and grill is cold, remove burner and
inspect for spider nests or rust. see natural haz-
ard and cleaning the burner assembly pages.
Turn off LP Tank. Leave lid open to allow flames
to die down. After cooling, clean food parti-
cles and excess grease from inside firebox area,
grease cup/pan/tray, and other surfaces
1. See instructions on control panel and
section in the Use and Care.
2. Make sure valve are positioned inside of burner tubes.
3. Ensure burner tubes are not obstruct-
ed with spider webs or other matted, see
cleaning section of use and care
4.Make sure LP tank is not empty. If LP tank is
not empty, refer to "sudden drop in gas flow.
5.Turn off knobs and disconnect coupling
nut from LP tank. Reconnect and retry.
6. Turn the coupling nut approximately.