Transmitter (Xrc-6S) - XciteRC Dragon 250 Bedienungsanleitung

down (1). Insert four AA batteries into the battery compartment of the transmitter (2). Pay attention to the
correct polarity!
EN
Battery
compartment cover
• Close the battery compartment cover, then turn on transmitter – push ON / OFF switch.
• The blue POWER LED must go on.
all - added by a beep tone, the model may not started – crash hazard! Change transmitter batteries
immediately.
• WARNING: check the POWER LED also during operation. If the POWER LED starts to blink, stop
operation, switch the model off and replace the transmitter batteries – crash hazard!
• ATTENTION: The maximum range of the remote control system is about 500 meters.

Transmitter (XRC-6S)

NOTE: for this model please select in the menu MODEL SET the model memory MOD5 and in the
menu PLANE TYPE model type Plane.
For detailled information please read also the manual of the transmitter XRC-6S.
22
-
1
-
4x 1.5 V AA
2
batteries
Attention: if the POWER LED flashes or does not light at
Transmitter
XciteRC Dragon 250