Maintenance; Residual Risk; Symbols On The Product - Ryobi RHT36C61R15S Übersetzung Der Original-Anleitung

leaking. Check with the forwarding company for further
advice.

MAINTENANCE

WARNING
Use only original manufacturer's replacement parts,
accessories, and attachments. Failure to do so can cause
possible injury, can contribute to poor performance, and
may void your warranty.
WARNING
Servicing requires extreme care and knowledge
and should be performed only by a qualifi ed service
technician. For service, have the product serviced by an
authorised service centre only. When servicing, use only
original replacement parts.
WARNING
The blades are extremely sharp. To prevent personal
injury, exercise extreme caution when cleaning,
lubricating, and fi tting or removing the blade protector.
■ Remove the battery pack before adjusting, maintaining,
or cleaning the product.
■ You may make adjustments or repairs described in
this manual. For other repairs, contact an authorised
service centre.
■ After each use, clean the product with a soft, dry cloth.
■ After each use, clean the debris from the blades
with a stiff brush, and then carefully apply a rust
preventative lubricant before refitting the blade
protector. The manufacturer recommends you to use
a rust preventative lubricant spray to apply an even
distribution and reduce the risk of personal injury from
contact with the blades. For information about suitable
spray product, check with an authorised service centre.
■ If needed, lubricate the blades lightly before use using
the above method.
■ Check all nuts, bolts, and screws at frequent intervals
for proper tightness to ensure the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.

RESIDUAL RISK

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and the
operator should pay special attention to avoid the following:
■ injury caused by contact with the cutting means
– The blades cannot be guarded while cutting.
Contact with the blades can cause serious injury.
Keep the blade away from yourself and others.
Cover it with the blade protector whenever you are
not cutting.
4 | English
■ injury caused by vibration
– Always use the right tool for the job, use designated
handles and restrict working time and exposure.
■ hearing damage caused by exposure to noise
– Wear hearing protection and limit exposure
RISK REDUCTION
It has been reported that vibrations from handheld tools
may contribute to a condition called Raynaud's Syndrome.
Symptoms may include tingling, numbness, and blanching
of the fi ngers, usually apparent upon exposure to cold.
Hereditary factors, exposure to cold and dampness, diet,
smoking, and work practices are all thought to contribute to
the development of these symptoms. There are measures
that can be taken by the operator to possibly reduce the
effects of vibration:
■ Keep your body warm in cold weather. When operating
the product, wear gloves to keep the hands and wrists
warm. It is reported that cold weather is a major factor
contributing to Raynaud's Syndrome.
■ After each period of operation, exercise to increase
blood circulation.
■ Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your physician.
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
KNOW YOUR PRODUCT
See page 140.
1. Blade
2. HEDGESWEEP debris sweeper
3. Guard
4. Operator presence switch
5. Front handle
6. Rotating rear handle trigger
7. Trigger
8. Rear handle
9. Charger
10. Battery latch button
11. Battery pack
12. Blade protector

SYMBOLS ON THE PRODUCT

Safety alert
Please read the instructions carefully
before starting the product.