Final Work - Siemens RVL480 Installationsanleitung

Final work

Locking the settings for district heat
The settings for district heat can be locked by linking terminals H3 and M.
Then, seal the fixing screw at the bottom: Insert plug (attached to the key ring) in the screw hole;
introduce a wire through both lugs and seal.
Completing the installation work
1. If settings have been entered in these instructions: keep instructions in a safe place
2. Make entries in the Operating Instructions:
– Setting choice of heating curve on page 13
– Heating engineer's name and address on page 31
3. Keep Operating Instructions inside the controller
4. Seal the transparent cover, if required
Building Technologies 74 319 0617 0 a 17.04.2008
en
41/180