Bringing the device into operation
Making the electrical connection
Connect the plug of the mains cable with an AC 230 V ~ 50 Hz socket.
The time will be shown in the display. The time will be shown as
up battery has been inserted.
Back-up battery
You can insert two batteries (type LR03/R03/AAA;
not included in the scope of the delivery), if you have
detached the device from the mains, so that the time
will continue to run in the background.
Pull out the mains plug.
Remove the cover of the battery compartment on
the bottom of the device.
Insert the batteries. Pay attention to the polarity (+/-) here.
Close the battery compartments and connect the mains plug with an
AC 230 V ~ 50 Hz mains socket again.
Set the time if the battery has already been inserted, in order to keep the time in
the memory in the case of an interruption of the mains operation.
ATTENTION!
A danger of explosion in the case of an improper replacement of the
batteries. Replacement only by the same or an equivalent type.
Set the time
Hold the CLOCK button pressed down. The hour display will flash.
Set the required hour with the or SKIP buttons.
Press CLOCK. The minute display will flash.
Set the required minutes with the or SKIP buttons.
The device will switch back to the Time mode after a few seconds, after you have
set the time.
if no back-
0:00
9
EN
EN
PL