Customer Service; Initial Help In The Case Of Malfunctions; Do You Need Additional Support; Cleaning And Care - Medion MD 82464 Bedienungsanleitung

 Press the SLEEP button several times. The '90' notice will flash in the display.
The value displayed will correspond to the minutes after which the device will
switch to Standby mode.
 Press the SLEEP button several times, in order to set a shorter time.
 Press SNOOZE several times, until the current type of operations appears in
the display again, in order to cut the SLEEP function short prematurely.

Customer service

Initial help in the case of malfunctions

Malfunctions can sometimes have commonplace causes, but at times they can
also be really complex and require an extensive analysis.
No sound
The volume has been set too low or the mains plug has not been correctly con-
nected to the mains socket.
 Increase the volume; insert the mains plug correctly.
The device does not react to operating commands
Electrostatic discharge.
 Re-boot the device, by removing the back-up batteries and pulling the mains
plug from the socket. Then, re-insert the batteries, plug the mains plug into
socket and switch the device on again.
Poor radio reception
An inadequate radio signal. Interference from other electrical devices, such as TV
devices, video recorders, computers, etc.
 Lay the wire aerial to its complete length or change its position and alignment.

Do you need additional support?

Please contact us if the suggestions above have not solved your problem. You
will help us very much if you make the following information available to us:

What displays can be seen?

What steps have you taken to solve the problem?

Inform us if you have already received a customer number.

Cleaning and care

ATTENTION!
Always pull the plug out under all circumstances before cleaning the
device.
Only use a clean, soft cloth to clean the device. Do not use any chemical solu-
tions or cleaning materials because they can damage the surface of and/or the
labels on the device.
14