Power supply
Connect the device only to a well accessible AC 230 V ~ 50 Hz domestic socket
close to the place of use. Keep the socket freely accessible, so that plug can be
pulled out unimpeded.
The nameplate is located on the base of the device.
Pull the plug out of the socket in principle after every use and before each cleaning.
Always pull the mains cable out of the socket at the plug; do not pull on the cable
itself.
Pull the plug out of the socket immediately in the case of damage to the plug, the
service cable or the device, of if liquid or a foreign body has reached the interior of
the device.
This device's ON/OFF switch does not cut it off completely from the mains. Further
more the device still consumpts power when switched off. To completely cut the
device from the mains, unplug the mains socket.
Setting up location / environment
New devices can emit a typical, unavoidable but completely harmless odour, which
will decline in the course of time, in the first hours of operation. We recommend you
to ventilate the room regularly, in order to counter the smell. We have taken care
that the applicable limits are clearly fallen below during the development of this
product.
Place and operate all components on a stable, level, vibration-free base, in order to
avoid accidents to the device.
Avoid extreme dust accumulations. Do not cover the ventilation slots to ensure
adequate ventilation. The ventilation should not be obstructed by placing objects,
such as newspapers, table cloths, curtains, etc. on the vents. Maintain a minimum
distance to walls and furniture of approx. 10 cm to the top and rear and approx. 5
cm to the other sides.
Pay attention that the device is not subjected to any direct sources of heat (such as
heating systems). Do not place the unit in direct sunlight.
No open sources of fire (such as lit candles) may stand on or close to the device.
Do not place any objects on the cable, because it could be damaged if you do so.
Use the device exclusively in the living room or in similar rooms.
Electro-magnetic compatibility
Maintain a minimum distance of one metre from high-frequency and magnetic
sources of interference (a television device, other loudspeakers, mobile and cord-
less telephones, etc.), in order to avoid malfunctions.
Use only the accessories supplied with the device.
EN
EN
PL
3