oventrop Regumat S-180 WMZ Einbau- Und Betriebsanleitung Seite 11

Controller
white
white
black
Illustr. 5.3 Connection diagram three point control
5.5 Heat meter connection set
The heat meter connection set is supplied with the
"Regumat".
Extent of supply:
– 2x Connection fitting G1 ½ male x G1 female
– 2x Connection fitting G1 male x G¾ male
– 2x Seal G1
– 2x Seal G¾
– 1x Plug M10x1 female with O-ring
Illustr. 5.4 Heat meter connection set
Installation of a heat meter with a length of 110 mm:
– Fix the female threaded connection fittings G
the supplied seals to the heat meter.
– Fix the female threaded connection fittings G1 with
the supplied seals to the mounted adapters.
– Fit the heat meter into the station with the help of
the enclosed collar nut sets.
– Remove the plug with O-ring on the supply side of
the isolating device (on supply on the right hand
side).
– Screw plug M10x1 with O-ring into the isolating
device.
– Screw flow temperature sensor of the heat meter
into the plug by use of the mounting material
supplied with the heat meter.
Controller
blue
white
brown
3
⁄ with
4
Installation of a heat meter with a length of 130 mm is
carried out in the same way, but the connection fittings
G ¾ female and the corresponding seals are not
required.
Length 110 mm
Illustr. 5.5 Installation heat meter connection set
5.6 Adaptation of the insertion block
Commercial heat meters may be integrated into the
product group. This calls for an individual adaptation
of the insertion block. Depending on the type of the
heat meter, different diameters can be cut out of the
insertion block. The perforations simplify cutting. If the
electronic components of the heat meter cannot be
integrated into the insulation, they have to be removed
from the heat meter and be mounted onto the wall
near the insulation. In this case, the insertion block
does not have to be adapted.
Illustr. 5.6 Insertion block with cutting for heat meter
Length 130 mm
11