Operation; Measures At The End Of Operation - HUPFER TTW/M Betriebsanleitung

Operation

Operation
5 Operation
ATTENTION
5.1 Operation
ATTENTION
NOTE
Loading
Lock the Tray transport trolley with the total lock brakes to prevent from rolling back.
Insert trays in the sideways guides.
Close the doors and lock it with the transport safety device.
Release the total brakes.
Carefully push or pull the Tray transport trolley to the destination place.
Unloading
Release the total brake and roll the Tray transport trolley to the destination.
At the destination, lock the casters with total brakes.
Unlock the doors.
Remove trays.
5.2

Measures at the End of Operation

To switch off the Tray transport trolley, proceed as follows:
Push or pull carefully the Tray transport trolley (if necessary) to the destination place.
Lock the casters with total brakes.
4330080_A0
Appliance damages
The Tray transport trolley may only be operated when it is in perfect condition
with regards to technical standards. The appliance must be checked for ex-
ternal visible damages and defects before each operation.
In case of damages, inform immediately the competent bodies and do not put
the Tray transport trolley into operation.
Appliance damages
Heavily loaded Tray transport trolleys can roll and tip over during the train
operation. Do not exceed the maximum traction speed of 2.49 m/h (4 km/h).
The maximum speed applies for flat and dry concrete and a path width of
98.44'' (2.5 m).
You can tighten up to three Tray transport trolleys in a row. Reduce the trac-
tion speed according to a change of a parameter.
Inductive operation
Only appropriate induction crockery released by HUPFER with portioned
meals on the intended markings of the trays may be used when the tray
transport trolley is used together with the inductive docking station.
During the operation there should be no GN containers, cutlery or any other
metal objects in the Tray transport trolleys.
Chapter 5
Page 21
Tray transport trolley
TTW/M