Installation (Basic Steps) - Eos Invisio Mini Montage- Und Gebrauchsanweisungen

Installation
1. Mount the heater feet
Remove both lower fixation screws holding the
terminal box side panel (Fig 2a)
Insert the heater feet with the open sides facing
up into the appropriate openings in the side
corners of the heater housing.
Fixate each foot with a 4.2x9.5 screw at the re-
quired height. After this insert back the screws of
the terminal box panel and secure them.
Fig. 2a
The feet allow to adjust the heater height to 77,
71 or 65 cm.
Fig. 2b
28
2. De-install the air deflector
Loosen 4 screws at the heater sides and 1 screw
in the middle of the rear side of the air deflector
(see fig 3).
Lift the air deflector upwards and take it off the
heater in order to gain access to the rock store
and heater interior.
adjustable feet
Fig. 3
3. Fill the stones into the rock store
Rinse the supplied stones with clear water before
filling them into the heater.
Place the heater at its designated position. Move
it against the rear sauna wall. The spacers at the
rear side will automatically ensure the correct
gap to the rear wall.
Now fill the stones into the rock store. Distribute
them evenly, make sure to leave sufficient spaces
between the stones for air circulation (see fig. 4
for details)
! Do not operate the heater without
the stones. Risk of fire!
Please observe the additional information in the
chapter "Sauna stones".
GB
air deflector
fixation screws