Milling Direction For Edges; Plunge Cutting; Pivot Handle; Using The Rip Fence - Parkside PSFS 250 A1 Bedienungs- Und Sicherheitshinweise

Operation

Milling direction for edges

Plunge cutting

Insert the bit into the work piece at an angle
of 45°.
Slowly straighten the bit to an angle of 90° to
begin the cut.
Note: The base plate
material surface.
Pivot handle (see Fig. F)
Note: Turning the grip during the start up opera-
tions is forbidden. Remove the plug from the socket
and make sure that the swivel lock
Pivot to horizontal
Press and hold the bevel stop
Turn the handle counter-clockwise
tical to horizontal until the bevel stop locks in.
10 GB
must be flush with the
7
7
is engaged.
13
.
13
from ver-
Pivot to vertical
Press and hold the bevel stop
Turn the handle clockwise
to vertical until the bevel stop locks in.
Using the rip fence (see Fig. G)
Loosen the wing bolts
and slide the guide bar for the circle- / rip
fence through the two openings in the bot-
15
tom of the base plate
facing down.
Position the tool the desired distance from the
edge of the work piece. Tighten the wing bolts
to secure the circle- / ripe fence
plate .
7
Cutting circles (see Fig. H)
Note: The position of the guide hole depends on the
desired result, either inside or outside of the edge
of the circle: inside for holes, outside for discs. The
radius can be set from ca. 5 to 16 cm.
Make a circle on the work piece.
Mark the centre and drill a hole into the hole
(plunge cut).
Drill a guide hole on the edge of the circle
(plunge cut) (guide hole diameter 3 mm).
Loosen the wing bolts
and slide the guide rod for the circle- / rip
fence set through the two holes in the bot-
15
tom of the base plate
facing down.
Insert the centring tip in the middle of the circle.
Adjust the distance of the circle- / rip fence set
so as to plunge the bit into the guide hole at
the edge of the circle.
Lock the base plate
bolts .
9
Press and hold the ON / OFF switch
power on the unit.
Slowly push the unit forward.
.
13
from horizontal
on the base plate
9
, with the rip fence
7
to the foot
15
in the foot plate
9 7
, with the centring tip
7
by tightening the wing
7
to
4
7
9
15