Installation Instructions - Merrychef Microcook TA1725 Anleitung

INSTALLATION
Remove packing material and protective film from the oven.
Check for obvious signs of transit damage. If necessary, inform the
supplier IMMEDIATELY.
LOCATION AND POSITIONING
Choose a site away from major heat sources.
DO NOT position so that hot air is drawn in from fryers, grills, griddles,
etc.
A heat barrier to the height of the oven must be installed if sited next to a
hob, stove or range.
Microcook TA1725
Microcook TA1925
Place the oven on a flat surface that is LEVEL, STRONG and STABLE.
Allow a minimum clearance of 50mm for Microcook TA1725 and 100mm for
Microcook TA1925 to the rear, top and each side to allow air to circulate
freely.
The air intake is located under each side and rear of the oven, even with
the clearance specified above it is important that airflow is as cool as
possible and not pre-heated by other appliances such as fryers, grills or
griddles.
Allow a minimum of 50mm (TA1725 ), 100mm (TA1925) clearance above
the oven for hot air to escape.
Allow sufficient clearance for the door to open fully upwards.
Do not affix labels/stickers to oven other than those applied by the
manufacturer
5
Note:
The air intake is located
under each side and at the
rear of the oven, even with
the clearance specified
below it is important that
airflow is as cool as
possible and not pre-heated
by other appliances such as
fryers, grills and griddles as
this will deteriorate the life
and performance of the
oven.
Note the minimum
recommended
clearance required for
air flow
WARNING:
Check that the
AIR FILTERS are in place
prior to operation
( see Main Features )