Problem Solving; Error Code Display; Technical Specification - Merrychef Microcook TA1725 Anleitung

PROBLEM SOLVING

Error code display

The Microcook TA oven will identify some of the most common problems by flashing an error
message code in the time display window.
Error code display
Please remember - No servicing or repairs should be carried out other than by an approved Service Engineer
Technical Specifications
Microcook TA1725
Microcook TA1925
Manufacturers recommended
clearances
Power Supply: See rating plate at rear of oven
This equipment complies with the following EEC directives:
EMC 89/336 EEC
LVD 73/23 EEC
Merrychef reserves the right to alter specifications without prior notice.
Fault
Door not fully shut.
Possible electrical fault
Oven has overheated
No time has been set.
Invalid time has been set. e.g. 61secs
The required cooking time for multiple
items exceeds 30minutes
Convected hot air failure
Display shows 0:00 but the cavity light
and cooling fans do not operate
Control panel lights do not operate with
oven connected to mains supply.
Height Width
( mm ) ( mm )
485 496
485 496
TA1725 50
TA1925 100 100*
*each side
15
Recommended action
Close door fully.
Call Merrychef Service Dept.
Clean air filter and vents
Leave oven switched on but not cooking
for 4-5 minutes.
Set a time
Set time in correct format 1:01
Remove one item and try again
Call Merrychef Service Dept.
Oven has gone into 'stand-by' mode, press
any pad to restart.
1. Check oven is connected to electrical
supply
2. Check fuse is correct value and in
good order.
3. Oven has overheated. Allow to cool
and check filters are clean
4. Call Merrychef Service Dept.
Depth Wt.
( mm ) ( kgs)
472 42.5
42.5
500
ote: For 2 ovens side by side clearance is 100mm
N
50* 50
ote: For 2 ovens side by side clearance is 200mm
100 N
Microwave
Heater Power
Power output
( watts )
( watts )
1400
800
1925 2000
Pt No. 32Z3386 Issue 05