Operating Instructions; Manual Mode - Merrychef Microcook TA1725 Anleitung

OPERATING INSTRUCTIONS: MANUAL MODE
The oven can be operated in
manual or programmed mode. It is
important to understand manual
mode prior to attempting program
operation.
1
Place the food in the centre of
the oven and close the door.
2 Set required cooking time by
pressing the numeric TIME
SELECT PADS.
Example: 2 Minutes 35 seconds
Only valid times of Minutes and Seconds
will be accepted.
e.g. 1minute 1 second not 61 secs
3
To cook the food press one of
the POWER PADS, Turbo or
Convected Heat (TA1925 only).
The LED within the selected pad
will light.
4 The timer will now count down.
When the remaining time
reaches zero the door will 'pop-
up'.
Remove the food from the
cavity.
5 To ensure the required core
temperature has been
reached , test the food with a
temperature probe before
serving. Taking normal
precautions to avoid burning
yourself, open the door and
remove the food.
DO NOT APPLY MICROWAVE ENERGY WHEN OVEN IS EMPTY
DO NOT USE THE OVEN WITHOUT
CLEAN AIR FILTERS IN POSITION
To familiarise yourself with the controls place a bowl containing
approximately 1.5 litres of water in the oven prior to operation.
Note: Model TA1925 power pads shown
10
WARNING:
MAXIMUM TIME
The time set cannot exceed 9
minutes 59 seconds
Total cooking for multiple items
cannot exceed 30 minutes.
( If 30 minutes is exceeded error
code E:3 will be dislayed)
TO STOP THE COOK CYCLE
The cycle may be stopped and
cancelled at any time by pressing
the CANCEL PAD
PAUSE
The cycle may interrupted by
opening the oven door.
On opening the door the timer will
be held at this point and the light on
the relevant
(microwave or convection) will flash
to indicate an interrupted cycle.
TO CONTINUE the cycle close the
door and press any power pad to
restart the timer.
'STAND BY' FACILITY
To conserve energy and extend
the life of components, the oven
will go into 'standby status if not in
use for approximately 5 minutes.
The interior light will go out, the
fans will stop and the displays will
dim.
Simply touch any pad to restart
the oven
POWER PAD