Running A Program - Merrychef Microcook TA1725 Anleitung

RUNNING A PROGRAM

Using number pad keys to run a programme
Programs 0 to 9 can be recalled using the number pad keys.
The following procedure should be used to activate these programs.
Place the food in the oven and
1
close the door
2 Press the PROGRAM PAD the
'P' will appear in the PROGRAM
DISPLAY.
3 Press the number pad key you wish to activate (0-9)
The program number and total cooking time appear
on the display and the first stage indicator will light.
example: Program 8
The program will now operate
with the total remaining time
counting down on the display.
When the time reaches "0:00"
an audible signal will be given.
4 Taking normal precautions to avoid burning yourself, open the door
and remove the food.
To ensure the required core temperature has been reached , test the
food with a temperature probe before serving. If necessary, repace the
food in the oven and cook for a little longer to achieve the required
core temperature.
MULTIPLE ITEM COOKING
This facility automatically calculates the cooking time required for two or
three food items when using a programmed cook cycle.
1 Enter the number of items to be cooked, i.e. 2 or 3.
2 Touch the program pad, a 'P' will
appear in the program display
3 Press the desired program selection pad. The required cooking time is
calculated and the cycle begins.
4 When the cooking cycle has finished, test the food with a temperature
probe before serving. If necessary, repace the food in the oven and cook
for a little longer to achieve the required core temperature.
13
TO STOP THE COOK CYCLE
The cycle may be stopped and
cancelled at any time by pressing
the CANCEL PAD.
PAUSE
The cycle may interrupted by
opening the oven door.
On opening the door the timer will
be held at this point and the light on
the relevant POWER
(microwave or convection) will flash
to indicate an interrupted cycle.
TO CONTINUE the cycle close the
door, an audible warning sounds
as a reminder to press any power
pad to restart the timer.
To review a program use
CALLBACK
PAD