Installation; Installation Options; Wall Installation - ABB TTF300 Inbetriebnahmeanleitung

Installation

3 Installation
3.1

Installation options

There are two ways to install transmitters:
•

Wall installation

• Pipe installation
Note
The transmitter is equipped with an LC display as standard.
3.1.1 Wall installation
Fig. 1
1 Wall
3 TTF300 transmitter
1. Locate an installation site close to the temperature sensor head.
Warning! General risks!
The transmitter can fall and be damaged if not firmly attached. There is also a risk that
persons can be injured.
Install the wall mount on a sufficiently stable wall only. Use only the recommended anchors
and screws.
2. Attach the wall mount securely with 4 screws (∅ 10 mm).
3. Screw the transmitter to the wall mount.
6 - EN
1
2
TTF300
2 Wall mount
3
A00089
CI/TTF300-X1