Service Data - AEG BP630302IM Benutzerinformation

Problem
The display shows "F102".
The display shows an error
code that is not in this table.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".

11.2 Service data

If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
Possible cause
• You did not fully close
the door.
• The door lock is defec-
tive.
There is an electrical fault.
The demo mode is activa-
ted.
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
ENGLISH
Remedy
• Fully close the door.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows
"F102" again, contact the
Customer Care Depart-
ment.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
1. Deactivate the oven.
2. Press and hold the but-
ton .
3. The first digit on the dis-
play and Demo indicator
start to blink.
4. Enter the code 2468 by
pressing the buttons
or to change the val-
ues and press
firm.
5. The next digit starts to
blink.
6. Demo mode deactivates
when you confirm the
last digit and the code is
correct.
27
to con-