Assembling The Stand; Caution During Assembly; Other Cautions; Assembly Procedure - Korg LP-180 Bedienungsanleitung

Assembling the Stand

At least one other person must help you
assemble the stand.

Caution during assembly

In order to assemble the stand safely, please observe the fol-
lowing points.
• Make sure that you have the correct part in the correct
orientation, and perform the assembly in the order given.
• The LP-180 may fall when applying force too much to the
front side of it before fixing the LP-180 to the stand. You
should be careful in handling it.

Other cautions

Please check the following points after assembly.
• Loosened screws
The screws may loosen as time passes after assembly.
You should periodically check whether any screws have
become loose. If you feel that the stand vibrates exces-
sively, it is possible that screws have come loose. If so, re-
tighten them.
• When moving the digital piano to another location
To move the assembled stand, remove the AC adapter
cord and the pedal cord from the stand, close the key
cover, and then move it slowly with at least two people
keeping it as level as possible.
• Disassembly
If you need to disassemble the stand, do so by reversing
the steps of the assembly procedure. After disassembly,
keep the screws and other parts in a safe place so that
they are not lost.
The LP-180 should always be laid down before it's
disassembled.

Assembly procedure

You'll need a Phillips (+) screwdriver.
1. Put the protective sheet, which had covered the LP-180,
on a flat floor, and place the LP-180 on that sheet with
its rear facing the floor.
Ensure that the LP-180's key cover will not to open
until the end of the assembly.
Protective sheet
8
Warning
LP-180
2. Make sure that all of the following parts are available.
Side panel (left)
Back board
Pedal cord
Screws (M6) x 8 pcs.
3. Fasten the LP-180 and the back borad to the right and
left side panels using eight screws (M6).
First temporarily tighten* the screws on the right side
panel, and then temporarily tighten* the screws on the
left side panel.
* To temporarily tighten the screws is to tighten them
leaving a clearance of about 2 mm.
Screws
(M6)
Side panel (left)
Be careful not to pinch your fingers.
4. Raise the assembled stand slowly with two people.
5. Then, firmly tighten all the screws that are temporarily
tightened in step 3.
When tightening the screws on the LP-180, adjust the up/
down and front/rear positions on the left and right side
panels so that they are equal.
6. Ensure that the stand has no gaps and is not tilted, and
that all the screws are tightened firmly.
7. Put caps on the screw heads on the right and left side
panels.
Side panel (right)
Pedal unit
Caps x 8 pcs.
LP-180
Screws
(M6)
Side panel (right)
Caps