Assembling The Stand; Caution During Assembly; Other Cautions; Assembly Procedure - Korg C1 Bedienungsanleitung

Assembling the Stand

Warning
● At least one other person must help you assem-
ble the stand.

Caution during assembly

• Make sure that you have the correct part in the correct ori-
entation, and perform the assembly in the order given.

Other cautions

• Loosened screws
The screws may loosen as time passes after assembly. You
should periodically check whether any screws have become
loose. If you feel that the stand vibrates excessively, it is pos-
sible that screws have come loose. If so, re-tighten them.
• When moving the digital piano to another location
To move the assembled stand, remove the AC adapter cord
from the stand, close the key cover, and then move it slowly
with at least two people keeping it as level as possible.
• Disassembly
If you need to disassemble the stand, do so by reversing the
steps of the assembly procedure. After disassembly, keep the
screws and other parts in a safe place so that they are not lost.

Assembly procedure

You'll need a Phillips (+) screwdriver.
1. Make sure that all of the following parts are available.
Side panel (left)
Speaker box
Pedal cord
Pedal unit
Anti-tipping Bracket
(left)
Screws (M6) Screws (M4)
x 2 pcs.
x 12 pcs.
2. Connect the attached pedal cord, observing the correct
orientation, to the connector on the reverse side of the
pedal unit, and then engage it with a slot in the pedal
unit.
The pedal cord can be attached to or detached from the
connector with its locking tab held down.
Side panel (right)
Pedal board
Anti-tipping Bracket
(right)
Push rivet x 1 pc.
Cord holder
x 1 pc.
Stabilizing felt x 4 pcs.
3. Insert the pedal unit into the pedal board, and then fas-
ten it by pressing a push rivet into the hole (above the
cutout) at the rear of the pedal board.
After pressing it into there, lift the pedal board to check
that the pedals do not drop. The pedal maunting pin will
prevent the pedal unit from falling out. Therefore, it cannot
be fully fastened to the pedal board.
Rear
Push
Front
4. Using four screws (M4), temporarily fasten the pedal
board (with the pedal unit attached) to the brackets at
the bottom of the inside of the left and right side panels.
* To temporarily tighten the screws is to tighten them leav-
ing a clearance of about 2 mm.
Side panel (left)
Screws
(M4)
Screws (M4)
5. Lift up the speaker box so that the brackets (A) on the
left and right side panels pass through the dents in the
speaker box. When the brackets (A) are fully hidden
within the speaker box, push the speaker box forward so
the rear of the speaker box is nearly flush with the edges
of the side panels. Then, the speaker box can be released.
Be careful not to pinch your fingers.
Locking
tab
Front of pedal board
Rear of pedal board
Push rivet
Side panel (right)
17