Check Following Assembly - Korg LP-180 Bedienungsanleitung

8. Connect the attached pedal cord, observing the correct ori-
entation, to the connector on the reverse side of the pedal
unit, and then engage it with a slot in the pedal unit.
The pedal cord can be attached to or detached from the
connector with its locking tab held down.
9. Connect the pedal cord to the connectors on the bot-
tom of the LP-180.
When connecting the pedal cord, observe the correct ori-
entations of the connectors. In addition, the pedal cord
can be attached to or detached from the connector with
its locking tab held down.
Locking tab
10. Use the cord holder next to the connector to hold the
pedal cord.
After securing the cord with the cord holder, ensure that
excess pressure is not applied to the connectors.
11. Connect the dedicated cord to the AC adapter. Then,
plug the AC adapter into the DC 12V connector, and
wrap the cord around the cord hook of the piano. For
details, refer to "1. Connecting the Power (Figure 1)"
on page 3.
12. Place the LP-180 where you intend to use it. Make sure
to place it in a safe location where the floor is flat and
stable.
When setting the digital piano in place, make sure
that the stand does not rest on the AC adapter cable
or pedal cable.

Check following assembly

□ Are any parts left over?
If any parts are left over, carefully review the assembly
procedure to see where those parts should have been
used.
□ Make sure that all screws are tight.
Locking
tab
Cord holder
Pedal cord
9