Medion MD 81210 Bedienungsanleitung Seite 88

Remote control
A SUBTITLE Press SUBTITLE again, in order to select another language for subtitles that are
available on the DVD
B ANGLE
Select the camera position (if available on the DVD)
C OSD
Repeat pressing the OSD during the playback, to display the current disc
position. The display will be changes at each press of the button
D PROGRAM
Program the playback sequence with this button
E SEARCH
Find a particular position on the disc
F STOP
Press STOP once, in order to stop the playback
G STEP/SLOW
Press this button during the playback, in order to proceed in slow motion. You
will change the slow motion speed each time the button is pressed: 1/2
1/4
H CLEAR
Delete the respective entries
TITLE Call up the title menu of the disc (after changing the Mode with SHIFT)
I
+10
J Enters the tens digit in the case of double digit numerals
Number buttons 0-9
K
L MUTE
Mute setting
M AUDIO
Press AUDIO again to select another spoken language (if supported by the DVD)
N SETUP
Opens the Set-up Menu
O MENU
Display the disc menu
P ENTER
Confirm entry

Q Navigate through the menu
R PREV/NEXT
Press this button, in order to jump to the start of a different title (CD) or chapter
(DVD).
S PLAY/PAUSE
Start playback /interrupt playback
T REV/FWD
Start a fast rewind or fast forward
U BACK Jump back to the start of the DVD with the BACK (after changing the Mode with
SHIFT).
V ZOOM
Press the ZOOM button. The image will be enlarged in the centre. The next
enlargement factor will appear each time the button is pressed:
2 3 4 1/2 1/3 1/4 OFF (after changing the Mode with SHIFT)
W A-B
Press the A-B button, in order to define the start of a section that is intended to
be repeated. Press A-B again, in order to define the end of the section. The
section will be repeated endlessly. Press A-B again, in order to return to normal
playback. (after changing the Mode with SHIFT)
X REPEAT
Press the REPEAT button during the playback. The section to be repeated will
appear on the screen each time the button is pressed (the entry will disappear
after a few seconds; after changing the Mode with SHIFT)
Y SHIFT
Use the function of a number button
The 'Invalid Key' message will appear if a function is not possible or is not available in the current
Mode.
6
1/5 1/6 1/7
1/3