hanseatic SY-3502D-E5-C59-L52-600 Gebrauchsanleitung Seite 36

Page EN-12 Materials required for assembly
Zimmerdecke
(5)
(7)
2. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
stovetop.
3. To keep the prescribed distances, draw
horizontal guides according to the above
diagrams.
If the socket is outside the area for the
fl ue screen, leave at least 5 cm room
between the ceiling and the wall mount (5).
16 cm
(5)
(7)
23 cm
4. Following the diagram shown above,
draw the six drill holes on the wall. Make
sure the distances between the holes are
correct.
5. Drill dowel holes at the marked areas
6. Place the dowels into the holes.
Attaching the Chimney hood
1. Screw the wall bracket (7) into the wall
with three screws.
(7)
2. Hook the exhaust hood (1) into the wall
mount (7).
3. Push down the lock on the grease filters
(12) and carefully remove the grease fil-
ters downwards.
(1)
(12)