For Your Safety; Intended Use; Explanation Of Symbols; Safety Notices - hanseatic SY-3502D-E5-C59-L52-600 Gebrauchsanleitung

Page EN-4

For your safety

For your safety

Intended use

This appliance is intended to be used
to remove cooking fumes and airborne
grease from a cooktop in a private
household. It is not designed for use in
a commercial setting.
Use the appliance exclusively as de-
scribed in this user manual. Any other
use is deemed improper and may result
in damage to property or even personal
injury. The manufacturer accepts no li-
ability for damage caused by improper
use.
Explanation of terms
The following symbols can be found in
this user manual.
WARNING
This symbol indicates a hazard with a
medium level of risk which, if not avoid-
ed, could result in death or serious inju-
ry.
CAUTION
This symbol indicates a hazard with a
low level of risk which, if not avoided,
could result in minor or moderate injury.
NOTICE
This symbol warns against possible
damage to property.
This symbol refers to useful addi-
tional information.

Explanation of symbols

Protection class 1

Safety notices

In this chapter you will fi nd general safe-
ty notices which you must always ob-
serve for your own protection and that
of third parties. Please also observe the
warning notices in the individual chap-
ters on operation, setup etc.
Risks in handling household
electrical appliances
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Only use the appliance indoors. Do
■
not use in wet rooms or in the rain.
The appliance corresponds to protec-
■
tion class 1 and may only be connect-
ed to a plug with a protective conduc-
tor that has been installed properly.
Do not connect to a multiple socket
■
outlet, power strip, timer or to a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
If the mains plug is no longer acces-
■
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
Take care to prevent the risk of trip-
■
ping when laying the mains cord.