Control Of The Number Of Manoeuvres Performed; Manoeuvre Counter Reset - Nice SLIGHT Installierungs-Und Gebrauchsanleitungen Und Hinweise

9.2.4 - Control of the number of manoeuvres performed
The number of manoeuvres performed as a percentage on the set limit can be
verified by means of the "Maintenance warning" function. Follow the indications
in Table 14 for this control.
01. Press and hold the "Set" key for about 3 seconds;
02. Release the "Set" key when the "L1" LED start to flash;
03. Press the " " or " " key to move the flashing LED onto L7, i.e. the "input LED" for the parameter
s t
"Maintenance notification";
04. Press and hold the "Set" key; the [Set] key must be kept pressed in continuation during steps 5, 6 and 7;
05. Wait approx. 3s after which the led associated with the current level of the parameter "Maintenance notification" will
light up;
06. Press and immediately release the "
07. The led corresponding to the selected level flashes a few times. The number of flashes indicates the percentage of
manoeuvres performed (in multiples of 10%) with respect to the set limit. For example: with the maintenance warning
set on L6 being 10000, 10% is equal to 1000 manoeuvres; if the LED flashes 4 times, this means that 40% of the
manoeuvres have been reached (being between 4000 and 4999 manoeuvres). The LED will not flash if 10% of the
manoeuvres hasn't been reached;
08. Release the "Set" key.
9.2.5 - Manoeuvre counter reset
After the maintenance of the system has been performed the manoeuvre coun-
ter must be reset.
Follow the instructions in Table 15 for this control.
01. Press and hold the "Set" key for about 3 seconds;
02. Release the "Set" key when the "L1" LED start to flash;
03. Press the "s" or "t" key to move the flashing LED onto L7, i.e. the "input LED" for the parameter
"Maintenance notification";
04. Press and hold the "Set" key; the "Set" key must be kept pressed during steps 5 and 6;
05. Wait approx. 3s after which the led associated with the current level of the parameter "Maintenance notification" will
light up;
06. Press and hold keys "s" and "t" for at least 5 seconds, then release them. The LED that corresponds to the selected
level flashes rapidly indicating that the; manoeuvre counter has been reset;
07. Release the "Set" key.
TABLE 14 - Control of the number of manoeuvres performed
" and " " keys;
s t
TABLE 15 - Manoeuvre counter reset
SET
3s
L7
or
SET
3s
and
.... n=?
SET
SET
3s
SET
L1
or L7
SET
3s
and
SET
English – 13