Getting Started; Attaching The Hoses - ULTIMATE SPEED 12 V UOP 12 C1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Disconnect the appliance
from the battery terminals
immediately after operation .
Using the appliance for
extended periods of time can
completely discharge vehicle
battery .
Do not carry the appliance by
the connecting cables or the
hoses . Keep the connecting
cables and hoses away from
hot parts of the vehicle or
sharp edges .
Store the appliance and the
used oil in a dry place and out
of reach of children .
Dispose of used oil and
soaked rags properly (see
"Disposal") . In order to protect
the environment, do not let
oils drain into the ground or
household drains .
Never use a damaged
appliance! Disconnect the
appliance from the vehicle
and contact your retailer if it is
damaged .
Never use accessories which
are not recommended by the
manufacturer . They could pose
a safety risk to the user and
might damage the appliance .
Only use original parts and
accessories .
10 GB/IE/NI
This product has been
classified as IPX4 and is
protected against splashing
water from any direction . Do
not immerse in water .
CAUTION! Do not immerse
the electrical parts of the
appliance in water or other
liquids . Never hold the
appliance under running water .
˜ Getting started

Attaching the hoses

1 . Remove the protective caps 7 (fig . A) .
2 . Straighten the suction hose 9 and the drain
hose .
11
3 . Install the suction hose (ø 6 mm) 9 onto the
suction hose connector 8 .
4 . Install the drain hose (ø 12 mm)
drain hose connector 6 .
5 . Secure both hoses 9 ,
hose clamps .
10
6 . Pay attention to the pumping direction
on the appliance .
Make sure that the hoses 9 ,
m
straightened to avoid damage.
˜ Operation
1 . Start the vehicle and run it for 5-10 minutes
to warm up the oil (60 °C is the maximum oil
temperature) . This reduces viscosity of the oil
and enables to pump it out more efficiently .
Do not pump the oil when the car
m
engine is running.
2 . Gently insert the suction hose (ø 6 mm) 9
into the bottom of the oil pan .
3 . Insert the drain hose (ø 12 mm)
container (e .g . oil collecting tray) .
4 . Set the on/off switch
position .
onto the
11
with the supplied
11
are
11
into a
11
to "O" (off)
1