Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
HELICOPTER
Stabilizer
Tail rotor
Landinggear
CONTROLLER
Throttle stick
Band selector (A, B, C)
"POWER ON" LED
1. Remove the screw
to release the battery
cover and slide
downwards.
Note: Before recharging and after every flight, always wait 10 to 15 minutes for the battery to cool down in order to avoid damage. Never leave the helicopter unattended when recharging.
1. Turn off the helicopter and the controller.
2. Pull out the charging wire from the bottom of
the controller (pic. 1).
3. Carefully plug the charging wire into the helicopter's
charging port (pic. 2). The charging wire should fit
easily into the charging port – DO NOT FORCE.
Inserting the charging wire incorrectly may damage
the helicopter and cause injury.
4. Turn the power switch on the controller to "ON"
(Charge) (pic. 3).
5. The red "Power ON" LED and the green
charge status LED now light up (Pic. 4).
6. Charging is complete when the green charge status
LED goes out.
7. After charging, turn the power switch to "OFF" and
remove the charging wire from the helicopter.
6
Helicopter and Controller
Insert Batteries
Charging the Helicopter
The helicopter can be fl own for about 8 minutes after
approximately 30 minutes of charging
Counter-rotating
rotor blades
LED lights
Infrared signal emitter
Direction stick
(forwards, backwards, left and right)
Power ON/OFF and
charge switch
Right and left trim dial
Charge status LED
2. Insert six 1.5 V AA batteries
following the polarity shown
inside the battery cover.
Pic. 1
Charging port
ON/OFF switch
Starting position
Note: Before turning
on the controller, the
throttle stick must be
in the down position.
Battery cover
3. Slide the battery
cover upwards and
screw in place.
Pic. 3
Pic. 4
Pic. 2
Werbung
Inhaltsverzeichnis
