Taking Out Of Service, Disposal; Taking Out Of Service; Disposal - KLEIBER KG 740 - LO Betriebsanleitung

10 Taking out of service, Disposal

10.1 Taking out of service

DANGER:
Removing electrically live cables risks injury and damage to equipment.
Never remove electrically live connecting cables. Before removing a cable, ensure that the power
supply has been switched off.
CAUTION:
Buckling and crushing cause destruction of the optical fiber!
The optical fiber must not buckled and chrushed while transported! While packaging, do not fall below
the minimal bend radius for the optical fiber (see Fix and connect the pyrometer (section 6.2.1) at page
15)!
Take the pyrometer out of operation as follows:
1. Switch off the power supply to the pyrometer
2. Remove the cables at the rear side of the pyrometer.
3. Remove the optical fiber at the front side of the pyrometer and from the fiber optics.
4. Protect the optical fiber and the fiber optics against scratches through suitable measures (e.g. protective
cap, foil, . . . ).
5. Dismantle the pyrometer from the mounting plate.
The pyrometer is thus out of operation.

10.2 Disposal

For disposal, you can return the pyrometer to KLEIBER Infrared GmbH (for address see
(section 3.3) at page 7, WEEE-Reg.-Nr. DE 23400844). For this you should pack the
pyrometer appropriately in the original packaging or use a cardboard carton with shock
absorbing PE material.
KS / KG / KGA 740 - LO
REFERENCE TO ENVIRONMENTAL PROTECTION:
Do not dispose of the pyrometer with domestic refuse!
10 Taking out of service, Disposal
19